Service
Hard landscaping & retaining walls
Retaining walls, paving, steps, driveways, boundary walls and yard concreting. Levels set out from a fixed datum and drainage designed in from the start, not added afterwards.
Most hard landscaping that fails does so for one of two reasons: the sub-base wasn't right, or the water had nowhere to go. Both are decided before anything visible gets laid.
Retaining walls
A retaining wall is a structure, not a garden feature. It has to hold back the weight of the soil behind it plus the water in that soil, and water is usually what does the damage. Behind every wall we build there's a drainage layer — geotextile, clean stone and a land drain taken to a proper outfall — so hydrostatic pressure never builds up in the first place.
We build mass concrete walls, reinforced block-and-fill walls and gravity walls depending on the height and the ground. Anything of significant height, or retaining a slope with a structure or driveway above it, should be designed by a structural engineer, and we'd tell you that before quoting rather than after.
Paving, patios and driveways
- Excavation to formation and a compacted sub-base laid in layers
- Falls set away from the house, typically around 1:80, so water runs to a gully rather than a wall
- Finished level kept clear of the damp-proof course — normally 150mm below it
- Natural stone, porcelain, concrete flag, cobble and block paving
- Permeable build-ups where surface water can't be discharged to a drain
- Kerbs, edgings, steps and thresholds
Yard and farm concreting
Concrete yards take heavier and more concentrated loading than a domestic driveway, and they need a slab specified for it. A typical yard pour is 150mm thick over a compacted stone base with mesh reinforcement, joints set out to control cracking, and falls run to a collection point. We've laid yards for farm and commercial use and can work either fully supplied or labour-only where the client is supplying materials direct.
Boundary walls and steps
Blockwork and stone boundary walls, capped and pointed, with foundations sized for the height. Steps set out with consistent rise and going, because inconsistent steps are both unpleasant and genuinely dangerous.
Common questions
Does a retaining wall need to be designed by an engineer?
Any wall of significant height, or one retaining ground that carries a structure, driveway or another wall above it, should be designed by a structural engineer. Low garden walls retaining a modest change in level generally don't need formal design, but the drainage behind them still matters. We'll tell you which category your wall falls into before quoting.
Do I need planning permission for a boundary wall?
Exempted development rules allow boundary walls up to certain heights, with lower limits applying to walls fronting a public road. The specifics depend on the location and the property, so confirm with your local authority's planning section before building.
How thick should a concrete yard be?
For general farm and commercial traffic, 150mm over a well-compacted stone base with mesh reinforcement is a common specification. Heavier or more concentrated loading, or poorer ground, may call for a thicker slab or a different reinforcement arrangement.
Will new paving cause drainage problems?
It can, if it's laid without thought. Replacing a permeable surface with an impermeable one increases the volume of water running off, and that water has to go somewhere. We either fall it to a gully connected to surface water drainage or use a permeable build-up that lets it soak away in place.
Can you work to a garden designer's drawings?
Yes. Send the layout and levels and we'll price and build from them.
Next step
Get a price on your job
Send us the address, what you're planning and any drawings you have. We'll come back with a realistic range before anyone spends time on a site visit.